ill try it again

Discussion in 'Blades' started by INRICK, Dec 4, 2010.


  1. INRICK

    INRICK Monkey+

    i guess no one liked my last knife post so ill try again.[violin]biglaff Picture030-1.
    Picture030-1.
     
  2. RightHand

    RightHand Been There, Done That RIP 4/15/21 Moderator Moderator Emeritus Founding Member

    Nice looking blade - Give it a little time INRICK [ Saturdays are a little slow and lazy in monkeyville
     
  3. INRICK

    INRICK Monkey+

    thanks RIGHTHAND
     
  4. melbo

    melbo Hunter Gatherer Administrator Founding Member

    Yeah. The knife guys are out in their shops on Saturday afternoons.

    Nice blade. Tell me a little about it.
     
  5. INRICK

    INRICK Monkey+

    4 1/2 inch blade #1 tooled steel with tame chestnut scales.
     
  6. Bison_Forge

    Bison_Forge Aspiring Knifemaker

    Nice! What did you use for the rivets?
     
  7. INRICK

    INRICK Monkey+

    i used brass rod.
     
  8. Bison_Forge

    Bison_Forge Aspiring Knifemaker

    It looks good, where did you get the rods from, and did you epoxy first?
     
  9. INRICK

    INRICK Monkey+

    i got the rod on ebay and yes i use opoxy for the scales
     
  10. 2RK

    2RK Monkey+

    I buy brass rod like 4 feet at a time for less then 10 bucks at fasnal or however they spell it, the bolt store....lol

    Nice knife whats the heat treat?
     
survivalmonkey SSL seal        survivalmonkey.com warrant canary
17282WuJHksJ9798f34razfKbPATqTq9E7