High Standard Victor

Discussion in 'Firearms' started by Seacowboys, Feb 5, 2009.


  1. Seacowboys

    Seacowboys Senior Member Founding Member

    There is a steel challenge near here next week. I have an open division gun (major) a production gun, and am putting an optic (holographic) sight on my High Standard to shoot Open .22 Division. I would like to mount a C-more but with the bucks so tight, I am looking at reasonable alternatives and was wondering if anyone has any recommendations?
    I am going to build a limited gun soon too; probably an STI .40. Anybody here shoot IPSC?
     
  2. RouteClearance

    RouteClearance Monkey+++

    Don't shoot IPSC, but I use Aimshot Holosight for bullseye competion. I have had this mounted to a S&W 22s, HK Tactical 45, and a Ruger GP100. They run anywhere from $125.00 to $200.00 each.

    Have had no problems with it on my 22, but would not recomend it for 357 mag loads or up, but it will suite you for what you want
     
  3. Seacowboys

    Seacowboys Senior Member Founding Member

    Great minds think alike; I just ordered one of those. I found it for $118.00 at My Gun Accessories. I still need to find a High Standard Mount although the sight rail has a short recessed area to "Weaver-mount" dimensions, there is no cut for the cross bolt and looks to be a few millimeters shorter than the base on the Aimshot. Maybe I can drill out a section of Picanny to fit the mount holes on my pistol.
     
  4. RouteClearance

    RouteClearance Monkey+++

    All my fellow bullseye shooters that shoot HS pistols have all there mounts done by others in the leauge who are tool and die makers, and machinest. You may have to do the same. I would not risk damaging a HS for a DIY type project.
     
  5. Seacowboys

    Seacowboys Senior Member Founding Member

    Brownell's has a mount that will work; just ordered it.
     
survivalmonkey SSL seal        survivalmonkey.com warrant canary
17282WuJHksJ9798f34razfKbPATqTq9E7