600v 3 phase generac

Well it wasn't easy, but it's on the ground. I'll open the covers and get a much data as possible by the weekend.

 

Picked up some free steel as well. There was a lot more, but it was sketchy trying to load it by myself without a lifting device.

 

Anyone live in southwest Michigan?

 

Any of these helpful?

 

Posted pictures

 

Picked up a trailer for it.

 

Loaded up

 

I was wrong about the hours...

 

I take it you got the output reconfigured?

 

I have yet to verify the current configuration. I was out of state for work since spring so I haven't had time to mess with it. All of the control circuits are wired to the 240v terminal blocks (i/o) and all of the 600v are left blank. Also the alarm settings seem to be setup as though it is tapped for 240v.

 

Well, I hope you get it right...too nice a unit to let the magic smoke out

 

https://www.google.com/url?sa=t&sou...FjAKegQIARAB&usg=AOvVaw3vYtW18enpOoazGQMIHt0x

Found a manual, hoping for zero smoke

 

Does anyone know where the dip switch for natural gas/propane would be located? Having issues locating it.

 

What is another name for it, Dip switch I havn't heard the expression before?

 

They are small two position switches normally affixed to a circuit board

 

Ah, Droop switches,If that is correct? I've seen these built into the voltage regulator control.

 

I found a bank of four on the governor, I'm just not sure which one. I cant locate an exact manual for this unit and would rather not damage it unintentionally. I called generac, and they don't have any record of it being built...

 

Is it marked Gain by chance?