International Scout Dodge 440 4x4 conversion

Discussion in 'Buy Sell Trade' started by ColtCarbine, Jun 14, 2010.

  1. ColtCarbine

    ColtCarbine Monkey+++ Founding Member

    I'm selling a complete Dodge Mopar 440 engine, Dodge 4x4 727 transmission with an International output shaft already installed. The transmission is married to a Dana 20 transfercase. I have two Dana 20 transfercases. Anybody wanting to convert their International Scout to a Mopar big block 440, this is for you.

    I will not part out the engine or separate the engine from transmission/transfercase, unless the transmission and transfercase sell first.. The engine is complete from the carburetor to the oil pan, has exhaust manifolds, water pump, alternator, power steering pump and all brackets, all the stock parts are there and assembled.

    According to previous owner, motor had been freshened up with a new Purple cam (RV type cam) and new rings (honed cylinders). I don't remember if he said a new timing set was installed or not. The motor/transmission has been sitting in an unfinished project for the last 3 yrs.

    Drivetrain is currently installed in a 1982 Jeep CJ-5 with full width one ton Chevy axles. I will remove motor/tranny once I have a serious buyer.

    I know this might be a long shot but you never know who might be lurking.

    <!-- START CLTAGS -->
  2. eddyt79

    eddyt79 Monkey+

    440 Engine

    Hey do you still have that engine and transmission?
  3. ColtCarbine

    ColtCarbine Monkey+++ Founding Member

    I apologize for not editing this posting. The drive train and Jeep are SOLD, post edited. Thank you for the inquiry.
survivalmonkey SSL seal warrant canary