One for Teresa

Discussion in 'Blades' started by Valkman, Jul 2, 2008.

  1. Valkman

    Valkman Knifemaker Moderator Emeritus Founding Member

    A couple of weeks ago I asked Teresa about trading for a flashlight she had and she turned around and just sent me 2 lights! Well, I had this CPMD2 Bird & Trout blank laying around and thought "Hmmm". :)

    I had stag but it was too short for the handle - so I drilled hardened CPMD2 with a carbide end mill and made a bolster and pinned it on. Then I put the stag on, and today ground it down and finished it.

    I must've took 50 pics but none really show this knife as nice as it is!

    Bird & Trout
    1/8" CPMD2 - HT by Bos
    416 SS bolster and pin
    Stag handles - 1/8" mosaic pins



    Hope you like it Sister T! [chopper]
    <!-- / message --><!-- sig -->
  2. Seacowboys

    Seacowboys Senior Member Founding Member

    Good for you, Don; That's a real beauty! I miss Tlynn; tell her that Seacowboys sends his regards.
  3. Quigley_Sharps

    Quigley_Sharps The Badministrator Administrator Founding Member

    Very Nice work man.
  4. Tracy

    Tracy Insatiably Curious Moderator Founding Member

survivalmonkey SSL seal warrant canary