Rifle Bore Cleaner

Discussion in 'Firearms' started by Quigley_Sharps, Oct 24, 2014.

  1. Quigley_Sharps

    Quigley_Sharps The Badministrator Administrator Founding Member

    I recently Discovered Bore Tech's rifle cleaning products.
    I have a magnum rifle that the accuracy was dropping off slowly.
    I use always use Sweets 762, Hops copper remover and Barns copper remover also use regular Hops.
    After all of those used on this barrel and the patches coming out looking clean the next day my shipment of boretech products arrived.
    I ordered their bore guide and a custom Length cleaning rod so I don't have to remove my muzzle brake. While I was there eye balling their cleaning rods I noticed the cleaners they have. I decided to try them all and see what happens.
    I ordered the carbon remover,copper remover and the Eliminator.
    The above picture is what the carbon remover took out after using the rest of my cleaners and thinking it was clean.
    The above is after using the copper remover.

    The above after using the Eliminator cleaner.

    This stuff works awesome. And it is all non-toxic and American made.

    Welcome to Bore Tech Inc
    Last edited: Jan 19, 2015
  2. Quigley_Sharps

    Quigley_Sharps The Badministrator Administrator Founding Member

    stg58 likes this.
  3. RouteClearance

    RouteClearance Monkey+++

    I bought a bottle of the Bore Tech 5 years ago and I have not used a tenth of the bottle.
  4. Cruisin Sloth

    Cruisin Sloth Special & Slow

    So afer all the cleaning report if the rifle has increased it's accuracy , or it's not the tool itself , but the tool user . ;)
    I know clean makes a huge difference for the smoothness & i Assumed !!! accuracy..

    Quigley_Sharps likes this.
  5. Quigley_Sharps

    Quigley_Sharps The Badministrator Administrator Founding Member

    Yea it went back to sub moa.
    When I finally realized something was wrong in the cleaning I was working up load developments for different bullets, and had nothing to refer to so I could see my accuracy loss. Util I went back to the load I sighted in with, then I could see it was the rifle and not the loads. It increased to a 2" group from a sub moa.
    stg58 and Cruisin Sloth like this.
  6. Mountainman

    Mountainman Großes Mitglied Site Supporter+++

    Thank you for the post Quig. Bought the same three that you did and used them tonight. Amazing what it gets out when you think it is clean.
    Quigley_Sharps likes this.
  7. BTPost

    BTPost Stumpy Old Fart Snow Monkey Moderator

    Quig... Excess Carbon after Shooting, is an indication of incomplete Burning of the Propellant.... You might look at using a slightly FASTER Powder, so it completely burns, BEFORE the Projectile leaves the Barrel, and the Pressure Drops.... And the Gases cool....
  8. Quigley_Sharps

    Quigley_Sharps The Badministrator Administrator Founding Member

    This a 300 ultra Mag pushing a 210 grain Berger, its overbore, you want to shoot the slowest powder you can to keep pressures down and get max accuracy/ velocity for long range shots.
    melbo likes this.
survivalmonkey SSL seal        survivalmonkey.com warrant canary